Europe Middle East Africa Change

 

 

 Product

 

 

BLUESIL SILICONE REMOVER is a corrosive liquid, so it is strongly advised to refer to the Safety Data Sheet before handling. In this Safety Data Sheet, users will find all the recommendations how to handle the product and specifically the appropriate personal protection.
To benefit from the optimum performance of BLUESIL SILICONE REMOVER it should be used on dry surfaces.
There are two possibilities for using:

  • Either by immersing the part to be cleaned in a tank containing BLUESIL SILICONE REMOVER.
  • Or by covering the silicone bead with wadding or paper or clothes impregnated with BLUESIL SILICONE REMOVER.

The duration of the removal of silicone product depends on its composition and thickness to be removed.
For example, to remove of cured product, you must leave on the BLUESIL SILICONE REMOVER 20 to 30 minutes.

Using a spatula, remove the product depolymerized then repeat the operation wetting or soaking if necessary.
Before dispensing a new silicone product, rinse with water then clean surfaces with a solvent such as isopropanol or heptan.
Restrictions
Before application, we advise you to check the compatibility of BLUESIL SILICONE REMOVER with the materials on which silicone products have been dispensed, particularly some substrates in PA or PMMA.

Avoid discharge into drains, water courses or onto the ground. Store in a cool, dry place with adequate ventilation. Keep away from incompatible materials, open flames, and high temperatures. Store in tightly closed original container. Avoid contact with oxidizing agents. For further information, refer to Section 10: "Stability and Reactivity". Suitable containers: Steel drums coated with epoxy-resin. Stainless steel.Please consult the Safety Data Sheet of this product.ELV;RoHS;WEEE

BLUESIL SILICONE REMOVER

BLUESIL SILICONE REMOVER is used to clean and remove cured silicone products on various substrates.

NON SILICONE

Fluid

ELV;RoHS;WEEE

BLUESIL SILICONE REMOVER is particularly suitable for removing silicone gasket without damaging the substrates.
It can be used on wood, plaster, concrete, glass, enamel, metal (stainless steel, anodized aluminum, aluminum coated ...), plastics (polypropylene, polycarbonate, PE, PVC ...).

BLUESIL SILICONE REMOVER was developed specifically for professional customers.
It can be used in many applications in order to replace or remove a silicone bead such as:
- Automotive (repair engine, gearbox ...)
- Maintenance (repair pump, heat exchanger ...)
- Construction (repair gasket expansion, sanitary seal...)

Asia Pacific;Europe Middle East Africa;Central and South America;North America

For information about Storage and Shelf Life for this product, please download the Technical Data Sheet.

 Characteristics_A

 

 

Viscosity10MonocompmPa.s
Flash point70MonocompAFNOR T 60°C

 Characteristics_B

 

 

 

 

 Table_Characteristics_A_And_B

 

 

 

 

 

 

 

 

 

 

 NeedAnExpert

 

 

 CS

 

 

 SS

 

 

 PressRelease

 

 

 

 

 Brochures

 

 

 TDS

 

 

 

 

 

 

 SQUARE_NEWS_EVENT_PRODUCT