Europe Middle East Africa Change

 

 

 Product

 

 

For maximum results, the following instructions must be very carefully complied with :
Surface preparation:
Each type of surface must be prepared accordingly. Refer to the specific processing data sheet for BLUESIL SEALANTS, RTV’s or CAF’s.


Note: the surfaces must be perfectly clean, dry and free from any dust or other matter than may impair adhesion.


Applying the primer:
Use a pad or a lint free cloth: special care should be taken to apply a uniform and very thin coat.
The primer is sensitive to atmospheric humidity, which may lead to the formation of a whitish deposit due to hydrolysis of the active ingredients when such a deposit is seen in the recipient, it should be discarded this is why it is important to tightly reseal the container each time after it has been used. It is good practice to pour the required amount into a separate container.
Care should be taken to protect the primer coating from any dirt whilst it is drying.

Comment: the primer is applied to a material surface at a temperature of between + 5 and +30°C; if the temperature is too high, rapid evaporation of the solvents might cause irregular primer coating.
When not in use, keep the container tightly sealed to avoid any hydrolysis of its active ingredients (appearance of a whitish deposit).

Consumption: approx. 50 g/m2
Drying time:
The drying time is especially dependent on room temperature, ambient humidity and on the porosity of the surface.
For example, at a temperature of around 20 °C, a drying time of around 15 minutes is required.
Comment: the elastomer should be applied as quickly as possible once the primer has dried, in order to avoid the primer surface becoming dirty (dust, moisture, greasy deposits, etc.).

 

Avoid discharge into drains, water courses or onto the ground. Store in a cool, dry place with adequate ventilation. Keep away from incompatible materials, open flames, and high temperatures. Nitrogen blanketing of containers is required. Avoid contact with oxidizing agents. Suitable containers: Steel drums coated with epoxy-resin.Please consult the Safety Data Sheet of this product.ELV;RoHS

BLUESIL PRIM 10073

BLUESIL PRIM 10073 is a product intended to improve the adhesion of BLUESIL one-component and two-component elastomers to metals and certain painted surfaces. The product is available as a ready-to-use solution of reactants diluted in a solvent.

Adhesion;Sealant;Sealing

Primer

Fluid

ELV;RoHS

BLUESIL PRIM 10073 is used with sealants in building construction and industrial applications on surfaces such as:

  • Aluminium,
  • steel,
  • stainless steel,
  • lead,
  • zinc,
  • alloys,
  • polyester powder coated substrates
  • fluorocarbonated resin based substrates.

Asia Pacific;Europe Middle East Africa;Central and South America;North America

For information about Storage and Shelf Life for this product, please download the Technical Data Sheet.

 Characteristics_A

 

 

Specific Gravity0.8Monocompkg/dm3
Flash point16Monocomp°C

 Characteristics_B

 

 

 

 

 Table_Characteristics_A_And_B

 

 

 

 

 

 

 

 

 

 

 NeedAnExpert

 

 

 CS

 

 

 SS

 

 

 PressRelease

 

 

 

 

 Brochures

 

 

Constructionhttps://www.bluestarsilicones.com/EN/Our_offer/KEC/ListInstance_Brochure_Title/Construction_Brochure.pdfConstruction

 TDS

 

 

 

 

 

 

 SQUARE_NEWS_EVENT_PRODUCT